HookEm
New Member
I put an aluminum disc in my mast step using 5200. However, I used a bit much and because it was clear I did not notice for 2 days, but now I see some on top of the aluminum disc. Anyone done this? How hard is it to get out? Any suggestions?
If I could get it loose, I'm sure I could use my shop vac. I've also considered putting sticky sand paper on the bottom of the mast and spinning it to sand it off.
If I could get it loose, I'm sure I could use my shop vac. I've also considered putting sticky sand paper on the bottom of the mast and spinning it to sand it off.