So I bought this minifish2 (for those who don’t know what that is, which is likely most of you because this boat is incredibly uncommon, it’s a cat rig Minifish, see the attached photos) at the beginning of the summer and I’ve been sailing the hell out of it. I want to get a new sail for it, because it still has the original sail from the 70s which is wearing down and has a few pinholes. My first thought was to just replicate the original sail (maybe throw on some classic sunfish colors) but I recently had a second idea: fatheading it. Now Ik it probably sounds pretty damn stupid, it’s a day sailing boat not a race boat, why would I do that? Well this boat preforms remarkably well in both light and medium wind, pretty comparably to a laser (I haven’t sailed alongside a laser yet but if my feel for it is right I would almost go as far as to say it’s faster than a laser though I don’t know how it compares when it comes to pointing ability and such) it’s definitely more nimble and maneuverable. So my question: would fatheading this somewhat performance boat be possible and if so, should it even be worth the effort for what I would get out of it? I personally know a sailmaker so the cost shouldn’t be too much of an issue, and I have access to a shop where I can manufacture parts relatively easily. I drew up a very rough sketch of what I was thinking of doing, attached below. For those of you out there who know your shit when it comes to this stuff and are cringing at my lack of knowledge, please be kind, I did little to no homework on this and I know it shows.